Us-sunlight SC12 Solar Controller Bedienungsanleitung PDF herunterladen

Table of Contents

1. What is included in this package

2. Tools required

3. Installation instructions

4. Solar Controller settings and operation

Tools Required

- Philips Screwdriver

Pre-Install Check

Please read the entirety of the instructions before proceeding with installation. If your Solar Attic Fan has already been

installed, please make sure the Solar Fan is working properly before installing the Solar Controller.

INSTALLATION TIPS - Before installing the Solar Controller Box in the attic, test and confirm proper communications

between Controller Box and Remote by following setup procedures.

Installation and

Operation Guide

Tel: 866-446-0966

www.ussunlight.com

[email protected]

A 2 - 8’ Cables

B Controller Box

C Remote Holder

D Remote

E 6 - Mounting Screws

F AC Power Adapter

G 2 - AAA batteries (not pictured)

H 2 - 6” long tie wraps (not pictured)

™

Setting up Solar Controller and the Remote

1. Connect AC Power Adapter to the Controller Box. Temperature and relative humidity

will be displayed.

2. The Controller Box has 2 slide switches, the one on the left is for selecting the Radio

Frequency (RF) channel and the one on the right is for selecting the temperature

readout in Celsius (°C) or Fahrenheit (°F). Align the RF channel (choice of 1,2 and 3)

of the Remote with the Controller Box. Both of them must be on the same channel in

order to send and receive signals. Select the desired temperature readout unit.

(fig 1a & 1b)

3. Remove the back panel of the Remote. Insert 2 AAA batteries (included) in the battery

compartment. Replace the back panel of the battery compartment.

4. Test the Remote by pressing the Status button once. This will establish the connection

between the Controller Box and Remote. You will hear a “beep” every time the Status button

is pressed. This verifies the Remote and Controller Box RF signals are aligned. If there is

not a beep, check that the RF channel selector is set to the same channel. If there is still

no beep, move both devices to an alternative channel and retry.

fig. 1b

fig. 1a

What is Included in the Box

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - Operation Guide

Table of Contents1. What is included in this package 2. Tools required3. Installation instructions4. Solar Controller settings and operationTools

Seite 2 - Remote Diagram

Attic Temperature Attic humidityThermo SwitchBattery CompartmentFan ModeHouse PowerSolar PowerStatusChannel SwitchThermo SwitchInstalling Solar Contro

Seite 3 - Standard Installation

1. Bring the complete Solar Controller Kit, including the Remote and Controller Box, to the attic.2. Check and make sure the Thermo Switch on the ba

Seite 4

fig. 14fig. 16 fig. 17fig. 15Installation with Use of Optional House ElectricityTo utilize the house electricity option with Solar Controller, connect

Seite 5 - Solar Controller Remote

Back of the Remote - Thermo Switch selector (ON or OFF)The Thermo Switch allows the user to engage or disengage the temperature control. U.S. Sunlight

Seite 6 - Power Source

Refer to this summary to interpret the LCD display and the fan’s operating status:LCD DisplayHouse PowerSolar PowerFan Operation Summary(Blank) ON ON•

Seite 7 - 4 or more fans

Multiple Fan Setup - 3 or less fansAssign one of the three available channels to each of the Solar Controllers. A beep sound will come from the Contro

Seite 8 - REGISTRATION

Manufacturer’s Limited WarrantyU. S. Sunlight Corp. (“Manufacturer”) warrants that certain of its product components are free from defects of workmans